Notify Alert - AT&T SynJ SB67158 User Manual

Getting started
Mailbox setup (for general mailbox)

Notify alert

Use this feature to receive notification calls to any phone number you set
(such as a cellular phone or paging device) after a new message has been
recorded to the general mailbox. To receive notification calls, you must save
the number you wish to be notified at to the telephone base, and then set
the system to call this number after it finishes recording a message.
If the number called has caller ID service, there will be an indication of the
notification call. When you receive a notification call, you hear about 15
seconds of silence; then the call is ended. There is no message sent and the
call is only made once. If the call is not picked up within three rings, the
telephone base cancels the call. You may not receive the call if the number
you set is busy, not available or off during the call.
1. When the telephone is idle, press MENU
2. Press or
3. Press or
Set alert number:
1. Press ENTER again to select Alert call #.
MENU/
2. Use the dial pad to enter the number (up to 32 digits)
of the cellular phone or paging device you want to be
notified.
• Press REMOVE to backspace and delete a digit.
• Press REP or SKIP to move the cursor to the left or right.
3. Press ENTER to save the setting and return to the previous menu.
MENU/
There is a confirmation tone. To exit without making changes, press EXIT.
Turn alert on or off:
1. Press or
2. Press or
3. Press ENTER to save the setting and return to
MENU/
the previous menu. There is a confirmation tone. To exit
without making changes, press EXIT.
to scroll to Mailbox setup. Press
to scroll to Notify alert. Press
to scroll to Alert on/off. Press
to scroll to On or Off.
.
/ENTER
MENU/
ENTER.
MENU/
MENU/
33
Set access code
ENTER.
Call screening
Notify alert
>
Remaining space
Alert call #
>
Alert on/off
Calling alert #
ENTER.
Alert on/off
:On
ENTER=Save