Snapshot Mode Timeout; Snapshot Aiming Pattern - Motorola MT2070 User Manual

6 - 6 MT2070/MT2090 User Guide

Snapshot Mode Timeout

Parameter # F0h, 43h
This parameter sets the amount of time the device remains in Snapshot Mode. The device exits Snapshot Mode
when you pull the trigger, or when the Snapshot Mode Timeout elapses. To set this timeout value, scan the bar
code below followed by a bar code from
30 seconds; values increment by 30. For example, 1 = 60 seconds, 2 = 90 seconds, etc.

Snapshot Aiming Pattern

Parameter # F0h, 2Ch
Select Enable Snapshot Aiming Pattern to project the aiming pattern when in Snapshot Mode, or Disable
Snapshot Aiming Pattern to turn the aiming pattern off.
*
Enable Snapshot Aiming Pattern
Appendix D, Numeric Bar
(01h)
Codes. The default value is 0 which represents
Snapshot Mode Timeout
Disable Snapshot Aiming Pattern
(00h)