Pattern Operation - Toshiba TOSVERT VF-AS1 Instruction Manual

3) S-pattern acceleration/deceleration 2
Select this pattern to obtain slow acceleration in a demagnetizing region with a small motor acceleration torque. This
pattern is suitable for high-speed spindle operation.
Output frequency [Hz]
Maximum frequency

Set frequency
Base frequency
0
Actual acceleration time
6.31

Pattern operation

 : Pattern operation selection
 : Pattern operation mode
 ,  : Number of repetitions of pattern group 1, 2
 ~  : Pattern group 1 selection 1~8
6
 ~  : Pattern group 2 selection 1~8
 ~  : Speed 1~15 operation time
• Function
These parameters allow you to combine a maximum of 30 operation frequencies, operation time and
acceleration/deceleration time (15 combinations of parameters x 2 patterns) for automatic pattern operation
by means of the terminal board.
[Parameter setting]
Title



 ~ 

 ~ 
 ~ 
* Forward/reverse, acc/dec time 1, 2, V/f 1, 2 can be set with  ~  (Preset speed operation frequency
1~15 operation modes). ⇒ For details, refer to Section 5.12.
Note:When the function of auto-restart is active, the time spent for speed search is added to the operation time set
for pattern operation. Consequently, the effective operation time sometimes becomes shorter than the settled
operation time.
 Time [s]
Function
Pattern operation selection
Pattern operation mode
Number of repetitions of pattern group 1
Pattern group 1 selection 1~8
Number of repetitions of pattern group 2
Pattern group 2 selection 1~8
Speed 1~15 operation time
Output frequency [Hz]
Maximum frequency

Set frequency
Base frequency
0
Adjustment range
 :Disabled,
 :Enabled (setting in seconds)
 :Enabled (setting in minutes)
 :Pattern operation reset when
system stops operation
 :Pattern operation continued
even after system stops
operation
 ~  ,  :Successive
 :Skip,  ~ 
 ~  ,  :Successive
 :Skip,  ~ 
 ~  (The unit depends
on the setting of  .)
 :Infinite (depends on the
stop trigger entered)
F-54
E6581445
 Time [s]
Actual deceleration time
Default setting






