Selection Of Operation Panel Stop Pattern - Toshiba TOSVERT VF-FS1 Instruction Manual

6.20.6 Selection of operation panel stop pattern

• Function
1)
2)
[Parameter setting]
6
6.20.7 Display of the head of the parameters
• Function
[Parameter setting]
6.20.8 Integral output power
• Function
: Selection of operation panel stop pattern
This parameter are used to select a mode in which the motor started by pressing the
operation panel is stopped when the
Slowdown stop
The motor slows down to a stop in the deceleration time set with
Coast stop
The inverter cuts off power supply to the motor. The motor comes to a stop after coasting for a while by
inertia. Depending on the load, the motor may keep running for a good long time.
Title Function
Selection of operation panel stop
pattern
: Head of the parameter display selection
The parameter can be set at the front of the setting monitor mode.
If selecting "1: ", the Wizard parameter "
Title Function
Head of parameter display
selection
: Integral output power retention selection
: Integral output power display unit selection
At the main power off ,it is selectable whether retention of integral output power values or not.
And also, the display unit is selectable.
key is pressed.
STOP
Adjustment range
0: Slowdown stop
1: Coast stop
" is not displayed.
Adjustment range
0: AUF
1: AUH
F-76
E6581381
key on the
RUN
(or ).
Default setting
0
Default setting
0