Selection Of Operation Panel Stop Pattern - Toshiba TOSVERT VF-FS1 Instruction Manual

6.20.6 Selection of operation panel stop pattern

 : Selection of operation panel stop pattern
• Function
1)
2)
[Parameter setting]

6
6.20.7 Display of the head of the parameters
 : Head of the parameter display selection
• Function
[Parameter setting]

6.20.8 Integral output power
 : Integral output power retention selection
 : Integral output power display unit selection
• Function
This parameter are used to select a mode in which the motor started by pressing the
operation panel is stopped when the
Slowdown stop
The motor slows down to a stop in the deceleration time set with  (or ).
Coast stop
The inverter cuts off power supply to the motor. The motor comes to a stop after coasting for a while by
inertia. Depending on the load, the motor may keep running for a good long time.
Title Function
Selection of operation panel stop
pattern
The parameter can be set at the front of the setting monitor mode.
If selecting "1:", the Wizard parameter "" is not displayed.
Title Function
Head of parameter display
selection
At the main power off ,it is selectable whether retention of integral output power values or not.
And also, the display unit is selectable.
key is pressed.
STOP
Adjustment range
0: Slowdown stop
1: Coast stop
Adjustment range
0: AUF
1: AUH
F-80
E6581381
key on the
RUN
Default setting
0
Default setting
0