Ccd Service Check; Flatbed Motor Service Check - Lexmark MX310 Series Service Manual

Actions
Step 6
Replace the flatbed unit. See
Did this fix the problem?
Step 7
Replace the controller board. See
page 231.
Did this fix the problem?

CCD service check

Actions
Step 1
Restart the device, and retry the scan / copy job. Repeat this step with a
few copy jobs.
Does the error return?
Step 2
Is the CCD ribbon cable properly connected to JCIS1 on the controller
board?
Step 3
Replace the flatbed unit. See
Did this resolve the issue?

Flatbed motor service check

Actions
Step 1
Ensure that the flatbed motor cable (JFB1) is connected.
Is the cable connected?
Step 2
Replace the flatbed unit. See
Is voltage present?
Step 3
Replace the controller board. See
page 231.
Did this solve the problem?
"Flatbed assembly removal" on page
"Controller board removal" on
"Flatbed assembly removal" on page
"Flatbed assembly removal" on page
"Controller board removal" on
Diagnostic information
Yes
The problem is solved. Go to step 7.
328.
The problem is solved. Consult the next level
Yes
Go to step 2.
Go to step 3.
The problem is solved. Replace the controller
328.
Yes
Go to step 2.
The problem is solved. Go to step 3.
328.
The problem is solved. Contact the next level
131
7015
No
of support.
No
No issue.
Properly connect cable
to JCIS1.
board. See "Controller
board removal" on
page 231.
No
Properly connect the
cable.
of support.