Trailing Edge Sensor (Mx310, Mx410) Removal - Lexmark MX310 Series Service Manual

5
Remove the power supply shield. See
6
Remove the duplex. See
7
Position the printer so that it sits on its left side.
8
Disconnect the cable JACM1 from the controller board.
9
Release the retainer spring (A) from the bracket (B).
10
Remove the screw (C).

Trailing edge sensor (MX310, MX410) removal

1
Remove the left cover. See
2
Remove the right cover. See
3
Remove the rear door and cover. See
302.
4
Remove the power supply. See
5
Remove the power supply shield. See
6
Remove the duplex. See
7
Disconnect the cable JACM1 from the controller board, and cut it near the frame.
"Power supply shield removal" on page
"Duplex removal" on page
A
"Left cover removal" on page
"Right cover removal" on page
"Rear exit door removal" on page 301
"Power supply removal" on page
"Power supply shield removal" on page
"Duplex removal" on page
Repair information
274.
B C
209.
226.
and
272.
274.
283
273.
"Rear cover removal" on page
273.
7015