Protocol Settings; Settings From The Control Panel - Canon imageRunner 6570 Network Manual

Protocol Settings

You can specify the protocol settings for the machine by using any of the following:
•
The machine's control panel
•
The Remote UI (via a web browser)
•
NetSpot Device Installer (Canon utility)
IMPORTANT
•
To configure settings with software other than the control panel of the machine or
NetSpot Device Installer, TCP/IP protocol must be supported by your network
environment.
•
Some items cannot be set using the Remote UI or NetSpot Device Installer. For details
about items that can be set with the Remote UI or NetSpot Device Installer, see "Network
Setting Items," on p. 9-2.
•
The following procedure describes sample settings using the control panel.
NOTE
•
For instructions on how to enter settings using the Remote UI, see Chapter 3,
"Customizing Settings," in the Remote UI Guide.
•
For more information on NetSpot Device Installer, see Chapter 7, "Using Utilities to Make
Network and Device Settings."

Settings from the Control Panel

The procedure for specifying the settings from the control panel is as follows.
IMPORTANT
Settings made from the control panel become effective when the machine is restarted
after the procedure.
NOTE
For instructions on how to enter characters using the touch panel display, see Chapter 2,
"Basic Operations," in the Reference Guide.
1
Press (Additional Functions).
4-9
Protocol Settings
4