Adjusting Twenty-Seven Speed Cassette Chain - Invacare Force Owner's Operator And Maintenance Manual

SECTION 8—SERVICE PROCEDURES
5. Run the chain around the bottom of the wheel sprocket and back up towards the hand
crank sprocket.
6. Attach the chain together using the master link (w/clip) provided.
7. To tension chain, refer to Refer to Replacing the Fork/Crank Assembly on page 46.
Hand Crank Sprocket
Assembles
STEP 5
Chain Derailleur and Wheel Sprockets
STEP 3
FIGURE 8.8 Installing Twenty-Seven Speed Cassette Chain

Adjusting Twenty-Seven Speed Cassette Chain

NOTE: For this procedure, refer to FIGURE 8.9.
1. Loosen, but DO NOT remove the clamp that secure the crank handles to the fork.
2. Slide the crank handles up and/or down until the proper tension on the chain is
achieved.
NOTE: The proper chain tension will be approximately ½‐inch of chain slack.
NOTE: If crank is in desired position but chain tension is not correct, links MUST be added to or
removed from the chain to correct the tension. This should be performed by a qualified technician.
3. Tighten the clamp that secure the crank handles to the fork securely.
Recumbent Handcycle Series
STEP 4
56
Part No 1114850