SECTION 9—OPTIONS
SECTION 9—OPTIONS
WARNING
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may result.
Installing Rear Safety Light
Safety Light
WARNING
Operation of the handcycle is subject to
Lens
all traffic rules and regulations. (This
Cover
may include the use of a safety light and
reflectors for dusk/night riding.)
Clamp
NOTE: For this procedure, refer to
FIGURE 9.1.
Batteries
Rear Seat Post
1. Remove the lens cover.
Set Screw
2. Insert the AAA batteries with correct
NOTE: Rear wheels removed for clarity.
polarity (+ or ‐).
FIGURE 9.1 Installing Rear Safety Light
3. Reinstall lens cover.
Mounting the Safety Light
1. Remove the set screw from the clamp on the safety light.
2. Position the clamp onto the rear seat post.
3. Install the set screw into the clamp and tighten securely.
Operating the Safety Light
1. Press GREY button to turn safety light on/off.
2. Remove lens cover and slide switch back and forth for pulse or constant mode.
60
Recumbent Handcycle Series
Part No 1114850