Adjusting Seat Fore/Aft - Xlt Gold And Top End Force Only - Invacare Force Owner's Operator And Maintenance Manual

Adjusting Seat Fore/Aft - XLT Gold and Top End Force
Only
NOTE: For this procedure, refer to FIGURE 6.7.
NOTE: Seat should be adjusted so that when seated with feet in the footrests, there is a slight bend
at the knee and a slight bend at the elbow when the hand pedal is furthest away.
1. Remove the seat upholstery. Refer to Replacing Seat Upholstery on page 58.
2. Loosen, but DO NOT remove the two mounting bolts and locknuts securing the two
back clamps to the seat rails.
3. Slide back clamps for (forward) or aft (rearward) along the seat rails to desired seat
position.
4. Securely tighten the two mounting bolts and locknuts securing the two back clamps
to the seat rails.
5. Reinstall the seat upholstery. Refer to Replacing Seat Upholstery on page 58.
6. If necessary adjust the back angle.
Mounting Bolt
and Locknut
FIGURE 6.7 Adjusting Seat Fore/Aft - XLT Gold and Top End Force Only
Part No 1114850
SECTION 6—RIDING POSITION
37
Seat Rails
Back Clamp
Recumbent Handcycle Series