Top End
XLT Gold
Crank
ONLY
Assembly Tab
Upper Threaded
Post and Locknut
Steering
Dampener
Top End
Upper Threaded Post and Locknut
Force
ONLY
FIGURE 8.4 Installing/Removing/Adjusting the Steering Dampener - For Top End XLT Gold
Installing Seven Speed Shifter Cable
NOTE: For this procedure, refer to FIGURE 8.5.
NOTE: This procedure applies to the Top End XLT only.
NOTE: The seven speed Shifter Cable runs
from the right side of the front frame to its
mounting position on the hand crank assembly.
1. Run the cable from the right‐side of the
fork assembly to mounting position on
the left side just below the hand crank
assembly.
2. Attach the seven speed shifter to the
hand crank assembly extension.
3. Secure with hardware provided.
Part No 1114850
Lower
Threaded
Post and
Locknut
Crank
Assembly Tab
and Force Only
SECTION 8—SERVICE PROCEDURES
(One Located on Both Sides
of the Handcycle Frame)
Steering
Dampener
Dampener
Clamp (Tab)
Cable
FIGURE 8.5 Installing Seven Speed Shifter
53
Socket Screws
Handcycle
Frame
Dampener
Clamp (Tab)
Handcycle
Frame
Hand Crank
Assembly
Extension
Shifter
Cable
Recumbent Handcycle Series