Using The Travel Ready Option; Removing/Installing The Camber Bar - Invacare Force Owner's Operator And Maintenance Manual

Using the Travel Ready Option

NOTE: For this procedure, refer to FIGURE 9.14 on page 67.
NOTE: This procedure is for Top End XLT Pro, Gold, and Top End Force models only.
The travel ready option allows the handcycle to be quickly and easily disassembled for
travel.
NOTE: Reverse the steps below to reassemble the handcycle.
1. Remove the rear wheels. Refer to Installing/Adjusting the Rear Wheel and
Quick‐Release Axles on page 42.
2. Remove the camber bar. Refer to Removing/Installing the Camber Bar on page 67.
3. Remove the footrests. Refer to Replacing/Adjusting the Footrest and Leg Guard on
page 32.
4. Remove the fork and front wheel. Refer to Removing/Installing the Fork ‐ Travel
Ready XLT PRO Equipped with Road Crown Compensator on page 68 or
Removing/Installing the Fork ‐ XLT Gold, and Top End Force Equipped with Steering
Dampener on page 69.

Removing/Installing the Camber Bar

NOTE: For this procedure, refer to FIGURE 9.14 on page 67.
NOTE: To install the camber bar, reverse the steps below.
1. Perform one of the following
• Adjustable Angle Seat on XLT Gold ‐ Seat support tube does not mount to camber
bar. Proceed to STEP 2.
• Adjustable Angle Seats Except XLT Gold ‐ Loosen, but DO NOT remove the two
hex screws securing the seat support clamps to the camber bar.
2. Loosen, but DO NOT remove the two hex screws securing the frame clamps to the
camber bar.
3. Slide the camber bar through the clamps.
Seat Support Clamp
(Not Present on XLT Gold)
Socket
Screws
Part No 1114850
Frame Clamp
FIGURE 9.14 Removing/Installing the Camber Bar
(Not Present on XLT Gold)
67
SECTION 9—OPTIONS
Seat Support Clamp
Camber Bar
Socket
Screws
Recumbent Handcycle Series