Adjusting Hand Crank; Adjusting Hand Crank Height - All Models Except Top End Xlt Gold - Invacare Force Owner's Operator And Maintenance Manual

SECTION 6—RIDING POSITION

Adjusting Hand Crank

DO NOT operate the handcycle if the hand crank obstructs your view. If the hand
crank obstructs your view, adjust the height before using the handcycle - otherwise
injury or damage may occur.

Adjusting Hand Crank Height - All Models Except Top End XLT Gold

NOTE: For this procedure, refer to FIGURE 6.4.
1. Loosen, but DO NOT remove the two
set screws securing the hand crank to
the fork stem.
2. Move the hand crank assembly up or
down on the fork stem until you are
comfortable with the position for
operational purposes.
NOTE: The hand crank should be positioned so
that when the hand is toward the front of the
handcycle, the arm is slightly bent. The arm
should NEVER be fully extended (locked) at
any point while cranking.
3. Tighten the hex nut to secure the hand crank in the desired position.
4. Tighten the chain if necessary. Refer to Adjusting Twenty‐Seven Speed Cassette Chain
on page 56.
Recumbent Handcycle Series
WARNING
FIGURE 6.4 Adjusting Hand Crank Height -
All Models Except Top End XLT Gold
34
Hand Crank
Set Screws
Fork Stem
Part No 1114850