SECTION 6—RIDING POSITION
SECTION 6—RIDING POSITION
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may result.
Replacing/Adjusting the Footrest and Leg Guard
NOTE: For this procedure, refer to FIGURE 6.1.
NOTE: If replacing footrest or leg guard, take note of current position.
Replacing/Adjusting Footrest
1. Remove the hex bolt and locknut that
secure the footrest to the fork.
2. If replacing footrest perform the
following:
A. Remove existing footrest from
clamp.
B. Insert new footrest into clamp.
3. Slide footrest to desired position.
4. Reinstall hex bolt and locknut. Tighten
securely.
5. Repeat STEPS 1‐5 for the opposite
footrest, if necessary.
Replacing/Adjusting Leg Guard
NOTE: This procedure is for Top End XLT,
XLT Jr., and XLT Pro ONLY.
1. Loosen the two allen screws on each
mounting clamp.
2. If replacing leg guard, preform the
following:
3. Remove existing leg guard from
clamps.
4. Insert new leg guard into clamps.
5. Position each mounting clamp onto the fork under the brake cable.
NOTE: The leg guard should surround, but not touch, the rear of the front tire.
6. Adjust leg guard to desired position.
7. Tighten the two allen screws on each mounting clamp securely.
Recumbent Handcycle Series
WARNING
Footrest Replacement/Adjustment
Fork
Clamp, Hex,
Bolt and
Locknut
Leg Guard Replacement/Adjustment
Rear of
Front Tire
Leg Guard
FIGURE 6.1 Replacing/Adjusting the
Footrest and Leg Guard
32
Footrest
Fork
Brake Cable
Allen
Screws
Mounting
Clamp
Part No 1114850