SECTION 6—RIDING POSITION
Adjusting Back Angle - XLT Gold
NOTE: For this procedure, refer to FIGURE 6.10.
1. Loosen, but DO NOT remove, the two socket screws located in the seat angle
adjustment clamp.
2. Perform one of the following:
• Increasing Back Angle ‐ While pushing down on the back support tube, push the
back down to the desired position.
• Decreasing Back Angle ‐ While lifting up on the back support tube, pull the back
upward to the desired position.
3. Securely tighten the two socket screws located in the seat angle adjustment clamp.
Socket
Screw
NOTE: Wheel not shown for clarity.
Recumbent Handcycle Series
FIGURE 6.10 Adjusting Back Angle - XLT Gold
Back Support Tube
Adjustment Holes
40
Part No 1114850