Adjusting Top End Xlt Gold Hand Crank - Invacare Force Owner's Operator And Maintenance Manual

Adjusting Top End XLT Gold Hand Crank

NOTE: For this procedure, refer to FIGURE 6.5.
Adjusting Hand Crank Height
1. Loosen, but DO NOT remove the hex nut securing the hand crank to the fork stem.
2. Loosen, but DO NOT remove the two set screws for the upper clamp.
3. Move the hand crank assembly up or down in the fork neck until you are comfortable
with the position for operational purposes.
NOTE: The hand crank should be positioned so that when the hand is toward the front of the
handcycle, the arm is slightly bent. The arm should NEVER be fully extended (locked) at any point
while cranking.
4. Tighten the hex nut to secure the hand crank in the desired position.
5. Tighten the two set screws on the upper clamp.
6. Tighten the chain if necessary. Refer to Adjusting Seven Speed Hub Chain on page 55
or Adjusting Twenty‐Seven Speed Cassette Chain on page 56.
FIGURE 6.5 Adjusting Top End XLT Gold Hand Crank
Part No 1114850
Hex
Nut
Fork Neck
Upper Clamp
and Set
Screws
Hand Crank
(Gear and Chain Not Shown)
35
SECTION 6—RIDING POSITION
Recumbent Handcycle Series