Assembling the Mast Actuator
DO NOT overtighten the nut and bolt. This damages the mounting bracket.
NOTE: For this procedure, refer to FIGURE 2.2.
1. Remove the top nut, top bolt, bracket,
and bushing from the mounting
bracket on the mast.
2. Position the mast actuator in the lift
arm mounting bracket.
3. Install the top nut, top bolt, bracket,
and bushing into the mounting bracket
and mast actuator.
4. Tighten securely.
Installing the Leg Actuator to the Base
NOTE: For this procedure, refer to FIGURE 2.3 on page 16.
1. Slide the leg actuator into the slot in the base of the lift. See Detail "B".
2. Perform the following to secure the leg actuator to the pivot bracket (Detail "A"):
Ensure that there is sufficient room to turn lift on its side and that floor area is clear
of debris. Otherwise, injury to personnel or damage to lift may occur.
A. Turn the lift on its side.
B. Position slot in leg actuator over the pivot bracket.
C. Install the pin through the leg actuator and pivot bracket and secure with hitch pin.
D. Return the lift to the upright position.
3. Perform the following to secure the leg actuator to the mast bracket (Detail "B"):
A. Position leg actuator between mast bracket.
B. Move the legs to align the holes in the leg actuator with the holes in the mast
bracket.
C. Install the pin through the holes of the leg actuator and mast bracket and secure
with hitch pin.
4. Plug the pendant control into the bottom of the control box.
Part No. 1145811
CAUTION
Mounting
Bracket
FIGURE 2.2 Assembling the Mast Actuator
WARNING
15
INSTALLATION
Top Nut
Bracket
Top Bolt
Bushing
Mast
Actuator
Stand Up Lift Model RPS350-2