Installation Codes And Standards - Vulcan-Hart GH30 Installation & Operation Manual

GH30
GH45
GH60
GH60T
GH72
GH72/45
GH45/72
GH60/72
Snorkel ® Ranges must not be included in back-to-back setups.
The following ranges are to be installed only on non-combustible floors:
GHM72
GHM45
GHM30
The installation location must allow adequate clearances for servicing and proper operation. A
minimum front clearance of 35" (88 cm) is required.
The range(s) must be installed so that the flow of combustion and ventilation air will not be obstructed.
Adequate clearance for air openings into the combustion chamber(s) must be provided. Make sure
there is an adequate supply of air in the room to allow for combustion of the gas at the burners.

INSTALLATION CODES AND STANDARDS

Your Vulcan range(s) must be installed in accordance with:
In the United States:
1. State and local codes.
2. National Fuel Gas Code, ANSI/Z223.1 (latest edition), available from American Gas Association,
Inc., 1515 Wilson Blvd., Arlington, VA 22209.
3. National Electrical Code ANSI/NFPA-70 (latest edition). Copies available from The National Fire
Protection Association, Batterymarch Park, Quincy, MA 02269.
In Canada:
1. Local codes.
2. CAN/CGA-B149.1 Natural Gas Installation Code (latest edition).
3. CAN/CGA-B149.2 Propane Installation Code (latest edition), available from The Canadian Gas
Association, 178 Rexdale Blvd., Etobicoke, Ontario, Canada M9W 1R3.
4. Canadian Electrical Code, CSA C22.2 No. 3 (latest edition). Copies may be obtained from The
Canadian Standard Association, 178 Rexdale Blvd., Etobicoke, Ontario, Canada M9W 1R3.
GH60T45
GH60/72
GH60T72
GH3/72
GHM30S
GHM60S
GHM60TS
GHM72S
GHXM72
GHXM45
GHXM60
GHM72/45S
GHM45/72S
GHM60/45S
GHM60T45S
GHM60/72S
GHM60T72S
GH6
GHX60
GH45/72
GHM45/72
GHM60/72
– 9 –
GHX60T
GHXM60S
GHXM60TS
GHX72
GHXM72S
GHX45
GHM60/45
GHM3/72
GHM72/45
GHM6