Assembly - Vulcan-Hart GH30 Installation & Operation Manual

ASSEMBLY

Ranges Mounted on Casters
When ranges are mounted on casters, you must use a connector (available from Vulcan-Hart) that
complies with the Standard for Connectors of Movable Gas Appliances, ANSI-Z21.69 (latest edition),
and a quick-disconnect device that complies with the Standard for Quick-Disconnect Devices
Complying With Gas Fuel, ANSI-Z21.41 (latest edition) or CAN 1-6.9 (latest edition).
Provide a gas line strain relief to limit movement of the range(s) without depending on the connector
and/or any quick-disconnect device or its associated piping to limit movement of the range(s). Attach
the strain relief to the rear of the range (Fig. 1).
Should it be necessary to disconnect the strain relief, turn off the gas supply before disconnection.
Reconnect the strain relief before turning the gas supply on and returning the range(s) to their
installation position.
Bumper Bars
CAUTION: Failure to install bumper bars may cause motor damage and will void the warranty.
Remove existing #10 screws. Position bumper bars as shown in Fig. 2. Replace #10 screws and secure
bumper bars.
CONNECT GAS LINE
STRAIN
RELIEF HERE
PL-51219
Fig. 1
BUMPER BAR
PL-51282
Fig. 2
– 10 –
(4) #10 SCREWS
BUMPER BAR