Leveling; Gas Connections - Vulcan-Hart GH30 Installation & Operation Manual

Gh series heavy duty gas ranges

Hide thumbs Also See for GH30:

Table of Contents

LEVELING

Unlevel range(s) will create battery installation problems in lining up the manifolding system, and result

in uneven cooked product. Using a carpenter's level, level the range(s) from front-to-rear and side-to-

side. With range in its exact location or battery position, adjust leg heights. If installing a battery of

equipment, begin with first unit in battery lineup. Adjust legs by turning feet until all legs are resting on

the floor. If "less legs base" or "toe base" is used, screw the leveling bolt until floor contact is made.

(Fig. 18)

PL-40051

Fig. 18

The casters provided for the ranges are the non-leveling type; therefore the floor must be reasonably

level or baked products will be uneven and performance will be inconsistent.

CAUTION: All gas supply connections and any pipe joint compound used must be resistant to

the action of propane gases.

Remove oven bottom(s) and baffles.

Remove upper manifold panel(s).

Connect gas supply to the range(s). Make sure the pipes are clean and free of obstructions, dirt, and

piping compound.

Codes require that a gas shutoff valve be installed in the gas line ahead of the range(s).

Ranges manufactured for use with propane gas are equipped with fixed orifices.

– 18 –

Table of Contents