Installation Codes And Standards; Assembly - Vulcan-Hart MG24C Installation & Operation Manual

INSTALLATION CODES AND STANDARDS

For proper installation procedures in the United States of America, refer to:
1. State and local codes.
2. National Fuel Gas Code, ANSI-Z223.1 (latest edition). Copies may be obtained from The
American Gas Assn., Inc., 1515 Wilson Blvd., Arlington, VA 22209.
3. National Electrical Code ANSI/NFPA-70 (latest edition). Copies may be obtained from The
National Fire Protection Assn., Batterymarch Park, Quincy, MA 02269.
In Canada, refer to:
1. Local codes.
2. CAN/CGA-B149.1 Installation for Natural Gas Burning Appliances and Equipment
(latest edition).
3. CAN/CGA-B149.2 Propane Installation Code (latest edition), available from The Canadian
Standards Association, 178 Rexdale Blvd., Etobicoke, Ontario, Canada M9W 1R3.

ASSEMBLY

Backsplash
1. Remove the backsplash components from the crating materials.
2. Check the backsplash component parts against the list below to ensure that all the required
parts for the backsplash installation have been obtained.
• If any parts are missing, contact your dealer or closest parts depot immediately.
Backsplash Component Parts
MG24C
Std. 4" (10 cm) Std. 11" (27 cm) Std. 11" (27 cm)
High
Backsplash (1) Backsplash (1)
Backsplash Backsplash
Channel (2) Channel (2)
Heat Shield (1) Heat Shield (1)
3. Assemble the required components as shown in Fig. 2.
4. Lift the assembly up and slide the channels into the space provided at the rear of the range –
this may require two people.
MODELS
MG36C MG48C
High
Backsplash (1)
Backsplash
Channel (2)
Heat Shield (1)
High
– 5 –
Fig. 2