General; Installation; Unpacking; Location - Vulcan-Hart GH30 Installation & Operation Manual

Installation, Operation and Care Of
MODEL GH SERIES HEAVY DUTY GAS RANGES
PLEASE KEEP THIS MANUAL FOR FUTURE REFERENCE

GENERAL

Vulcan ranges and ovens are produced with quality workmanship and material. Proper installation,
usage and maintenance of your range will result in many years of satisfactory performance.
The manufacturer suggests that you thoroughly read this entire manual and carefully follow all of the
instructions provided.

INSTALLATION

UNPACKING

This range was inspected before leaving the factory. The transportation company assumes full
responsibility for safe delivery upon acceptance of the shipment. Immediately after unpacking, check
for possible shipping damage. If the range is found to be damaged, save the packaging material and
contact the carrier within 15 days of delivery.
Carefully unpack range(s) and place in the approximate installation position, whether as a battery or
single stand-alone range. Remove all shipping wire and wood blocking. Remove parts (packed in a
cardboard box) from oven cavity, or cabinet body, or on top of modular range(s).
Before installing, check the electrical service (Convection Oven Models only) and type of gas supply
(natural or propane) to make sure they agree with the specifications on the rating plate located on the
lower left-hand corner of the front frame behind the bellcrank. If the supply and equipment
requirements do not agree, do not proceed with the installation. Contact your dealer or Vulcan-Hart
Company immediately.

LOCATION

CAUTION: The equipment area must be kept free and clear of combustible substances.
The following ranges, when installed, must have a minimum clearance from combustible construction
of 6" (15 cm) at the sides and 6" (15 cm) at the rear. Clearance from non-combustible construction can
be 0" (0 cm) at the sides and rear:
– 8 –