Setting The Zone 2/3 Out; Controlling Multi Zone Components - Integra DTR-50.5 Instruction Manual

Setting the Zone 2/3 Out

See "Multi Zone" (➔ page 73).

Controlling Multi Zone Components

■
Operating on the AV receiver
Zone 2, Off Tone
– +
Zone 3, Off ,
Input selector buttons
Tip
• The Whole House Mode function shares the input source of
main room with Multi Zone (➔ page 51).
1 To turn on Zone 2/3 and select an input source,
press Zone 2 or Zone 3 followed by an input
selector button within 8 seconds.
Zone 2/3 turns on, the Z2 or Z3 indicator lights on
the AV receiver's display.
Tip
• The corresponding trigger output goes high (+12 V).
To select AM or FM, press Zone 2 or Zone 3 and
the Tuner input selector repeatedly.
To select the same source as the main room's,
press Zone 2 or Zone 3 twice. "Zone 2 Selector:
Source" or "Zone 3 Selector: Source" appears
on the AV receiver's display.
2
To turn off Zone 2/3, press Off for each Zone.
The zone is turned off.
Tip
• The corresponding trigger output goes low (0 volts).
■
Operating on the remote controller
To control Zone 2/3, you must press Zone on the
remote controller first.
Zone turns red when Zone 2 is on, and green when
Master Volume
Zone 3 is on.
1 Press Zone repeatedly, then point the remote
controller at the AV receiver and press
Receiver.
Zone 2/3 turns on, the Z2 or Z3 indicator lights on
the AV receiver's display.
Tip
• The corresponding trigger output goes high (+12 V).
2
To select an input source for Zone 2/3, press
Zone repeatedly, followed by an Input Selector
button.
To select AM or FM, press Zone and the Tuner
input selector repeatedly.
Receiver
Zone
Input selector buttons
Muting
VOL /
En-79
Advanced Operations
3
To turn off Zone 2/3, press Zone repeatedly,
followed by Receiver.
The zone is turned off.
Tip
• The corresponding trigger output goes low (0 volts).
Adjusting the Volume for Zones
■
Operating on the remote controller
1 Press Zone repeatedly.
2
Use VOL / .
■
Operating on the AV receiver
1 Press Zone 2 or Zone 3 (the Z2/Z3 indicator on
the AV receiver's display flashes).
2
Use Master Volume control within 8 seconds.
If your Zone 2/3 speakers are connected to a receiver
or integrated amplifier in Zone 2/3, use its volume
control to adjust the volume.
Muting Zones
■
Operating on the remote controller
1 Press Zone repeatedly, and then press Muting.
Tip
• To unmute, press Zone followed by Muting again. Zones
can also be unmuted by adjusting the volume.