Listening To Am/Fm Radio - Integra DTR-50.5 Instruction Manual

Listening to AM/FM Radio

This section describes the procedure of using the
buttons on the front panel, unless otherwise specified.
Using the Tuner
With the built-in tuner you can enjoy AM and FM radio
stations. You can store your favorite stations as
presets for quick selection.
You can also change the frequency steps
(➔ page 73).
1
Press Tuner to select either "AM" or "FM".
In this example, FM has been selected.
Each time you press Tuner, the radio band
changes between AM and FM.
Band Frequency
(Actual display depends on the country.)
Tuning into Radio Stations
■
Auto tuning mode
1 Press Tuning Mode so that the AUTO indicator
lights on the AV receiver's display.
2
Press Tuning / .
Searching stops when a station is found.
When tuned into a station, the TUNED indicator
lights. When tuned into a stereo FM station, the
FM STEREO indicator lights as shown.
Tip
• Tuning into weak FM stereo stations
If the signal from a stereo FM station is weak, it may
be impossible to get good reception. In this case,
switch to manual tuning mode and listen to the station
in mono.
■
Manual tuning mode
In manual tuning mode, FM stations will be in mono.
1
Press Tuning Mode so that the AUTO indicator
goes off on the AV receiver's display.
2
Press and hold Tuning / .
The frequency stops changing when you release
the button.
Press the buttons repeatedly to change the
frequency one step at a time.
En-39
■
Tuning into stations by frequency
You can tune into AM and FM stations directly by
entering the appropriate frequency.
1 On the remote controller, press Tuner
repeatedly to select "AM" or "FM", followed by
D.TUN.
TUNED
AUTO
(Actual display depends on the country.)
FM STEREO 2
Within 8 seconds, use the number buttons to
enter the frequency of the radio station.
For example, to tune to 87.5 (FM), press 8, 7, 5
or 8, 7, 5, 0.
If you have entered the wrong number, you can
retry after 8 seconds.
Presetting AM/FM Stations
You can store a combination of up to 40 of your
favorite AM/FM radio stations as presets.
1
Tune into the AM/FM station that you want to
store as a preset.
See the previous section.
2 Press Memory.
The preset number flashes.
(Actual display depends on the country.)
3
While the preset number is flashing (about 8
seconds), use Preset
from 1 through 40.
Playback
/ to select a preset