Setting The Zone 2/3 Out; Controlling Multi Zone Components - Integra DTR-30.4 Instruction Manual

Setting the Zone 2/3 Out

See "Multi Zone" (➔ page 64).

Controlling Multi Zone Components

■
Operating on the AV receiver
Zone 2, Off Tone
Zone 3, Off – +
,
Input selector buttons
Tip
• The Whole House Mode function shares the input source of main
room with Multi Zone (➔ page 44).
1
To turn on Zone 2/3 and select an input source,
press Zone 2 or Zone 3 followed by an input
selector button within 8 seconds.
Zone 2/3 turns on, the Z2 or Z3 indicator lights on the
AV receiver's display.
Tip
• The corresponding trigger output goes high (+12 V).
To select the same source as the main room's, press
Zone 2 or Zone 3 twice. "Z2 Sel: Source" or "Z3
Sel: Source" appears on the AV receiver's display.
2 To turn off Zone 2/3, press Off for each Zone.
The zone is turned off.
Tip
• The corresponding trigger output goes low (0 volts).
■
Operating on the remote controller
To control Zone 2/3, you must press Zone2 or Zone3 on
the remote controller first.
Receiver
Zone2
Master Volume
Zone3
1
Press Zone2 or Zone3, then point the remote
controller at the AV receiver and press Receiver.
Zone 2/3 turns on, the Z2 or Z3 indicator lights on the
AV receiver's display.
Tip
• The corresponding trigger output goes high (+12 V).
2
To select an input source for Zone 2/3, press Zone2
or Zone3, followed by an Input Selector button.
3 To turn off Zone 2/3, press Zone2 or Zone3,
followed by
The zone is turned off.
Tip
• The corresponding trigger output goes low (0 volts).
Input
Selector
Muting
VOL /
Receiver.
En-69
Advanced Operations
Adjusting the Volume for Zone 2/3
■
Operating on the remote controller
1 Press Zone2 or Zone3.
2
Use VOL / .
■
Operating on the AV receiver
1 Press Zone 2 or Zone 3(the Z2 or Z3 indicator on
the AV receiver's display flash).
2
Use Master Volume control within 8 seconds.
If your Zone 2/3 speakers are connected to a receiver or
integrated amplifier in Zone 2/3, use its volume control to
adjust the volume.
Muting Zone 2/3
■
Operating on the remote controller
1
Press Zone2 or Zone3 followed by Muting.
Tip
• To unmute, press Zone2 or Zone3 followed by Muting again.
Zone can also be unmuted by adjusting the volume.