Table of Contents
Advertisement
Zone 2 Video Output
The AV receiver features a composite video output for
connection to a TV in Zone 2, so you can enjoy both audio
and video in that zone.
Hookup
• Use a composite video cable to connect the AV receiver's
ZONE 2 OUT V jack to a composite video input on your
Zone 2 TV.
Main room
TV
AV receiver
Zone 2
TV
Note
• The ZONE 2 OUT V jack only outputs video from components
connected to composite video inputs.
Setting the Zone 2/3 Out
See "Multi Zone" (➔ page 66).
Controlling Multi Zone Components
■
Operating on the AV receiver
Zone 2, Off
Tone
Zone 3, Off
–
+
,
Input selector buttons
Tip
• The Whole House Mode function shares the input source of main
room with Multi Zone (➔ page 46).
1
To turn on Zone 2/3 and select an input source,
press Zone 2 or Zone 3 followed by an input
selector button within 8 seconds.
Zone 2/3 turns on, the Z2 or Z3 indicator lights on the
AV receiver's display.
Tip
• The corresponding trigger output goes high (+12 V).
To select the same source as the main room's, press
Zone 2 or Zone 3 twice. "Zone 2 Selector: Source"
or "Zone 3 Selector: Source" appears on the AV
receiver's display.
2
To turn off Zone 2/3, press Off for each Zone.
The zone is turned off.
Tip
• The corresponding trigger output goes low (0 volts).
■
Operating on the remote controller
To control Zone 2/3, you must press Zone2 or Zone3 on
the remote controller first.
En-71
Receiver
Master Volume
Zone2
Zone3
1
Press Zone2 or Zone3, then point the remote
controller at the AV receiver and press Receiver.
Zone 2/3 turns on, the Z2 or Z3 indicator lights on the
AV receiver's display.
Tip
• The corresponding trigger output goes high (+12 V).
2
To select an input source for Zone 2/3, press Zone2
or Zone3, followed by an Input Selector button.
3
To turn off Zone 2/3, press Zone2 or Zone3,
followed by
The zone is turned off.
Tip
• The corresponding trigger output goes low (0 volts).
Advanced Operations
Input
Selector
Muting
VOL /
Receiver.
Hide quick links:
Advertisement
Table of Contents
