Setting The Zone 2 Out - Integra DTR-6.8 Instruction Manual

DTR-6.8_En.book Page 111 Wednesday, June 20, 2007 4:16 PM
Zone 2—Continued
.

Setting the Zone 2 Out

If you've connected your Zone 2 speakers to a power
amp with no volume control in Zone 2, as explained in
"Using Another Amp in Zone 2" on page 109, you must
set the Zone 2 Out setting to Variable.
When set to Variable, the ZONE 2 OUT L/R jacks work
like pre outs.
1
Press the [Receiver] button fol-
lowed by the [Setup] button.
The main menu appears onscreen.
2
Use the Up and Down [
buttons to select "7. Hardware
Setup," and then press [Enter].
The Hardware Setup menu appears.
7. Hardware Setup
1. Remote Control
2. Zone2
3. Tuner
4. Analog Multich
5. HDMI
6. Network
3
Use the Up and Down [ ]/[ ]
buttons to select "2. Zone2," and
then press [Enter].
The Zone2 menu appears.
7–2. Zone2
Powered Zone2
Zone2 Out
4
Use the Up and Down [
buttons to select "Zone2 Out,"
and use the Left and Right [
[ ] buttons to select:
Fixed: The Zone 2 volume must be
set on the amp in that zone.
Variable: The Zone 2 volume can be
set on the AV receiver.
5
Note:
This procedure can also be performed on the AV receiver
by using its [Setup] button, arrow buttons, and [Enter]
button.
]/[ ]
Not Act
Fixed
]/[ ]
]/
Press the [Setup] button.
The setup menu closes.
111