Connecting Integra/Onkyo Ri Components; Using Headphones - Integra DTR-50.5 Instruction Manual

Connecting Integra/Onkyo RI
Components
1 Make sure that each Integra/Onkyo component
is connected with an analog audio cable
(connection in the hookup examples)
(➔ page 16).
2
Make the connection (see the illustration).
3
If you're using an RI Dock, or cassette tape
deck, change the Input Display (➔ page 51).
With (Remote Interactive), you can use the
following special functions:
■
System On/Auto Power On
When you start playback on a component connected
via , while the AV receiver is on standby, the AV
receiver will automatically turn on and select that
component as the input source.
■
Direct Change
When playback is started on a component connected
via , the AV receiver automatically selects that
component as the input source.
■
Remote Control
You can use the AV receiver's remote controller to
control your other -capable Integra/Onkyo
components, pointing the remote controller at the AV
receiver's remote control sensor instead of the
component. You must enter the appropriate remote
control code first (➔ page 83).
e.g., cassette tape deck
RI Dock
Note
• Use only cables for connections.
supplied with Integra/Onkyo components.
• Some components have two jacks. You can connect
either one to the AV receiver. The other jack is for
connecting additional -capable components.
• Connect only Integra/Onkyo components to
Connecting other manufacturer's components may cause a
malfunction.
• Some components may not support all
to the manuals supplied with your Integra/Onkyo
components.
• While Zone 2/3 is on, the System On/Auto Power On and
Direct Change functions do not work.
En-21

Using Headphones

1 Connect a pair of stereo headphones with a
standard plug (1/4 inch or ø 6.3 mm) to the
Phones jack.
While the headphones plug is inserted in the
Phones jack,
indicator FL and FR lights.
Note
• Always turn down the volume before connecting your
headphones.
• While the headphones plug is inserted in the Phones
R L
ANALOG jack, the speakers are turned off. (The Zone 2/3
AUDIO OUT
speakers are not turned off.)
• When you connect a pair of headphones, the listening
mode is set to Stereo, unless it's already set to Stereo,
Mono, or Direct.
R L
ANALOG
AUDIO OUT
cables are
jacks.
functions. Refer
Connections
indicator, speaker/channel