DFI-ITOX LT600-DR User Manual page 79

Keyboard 98 When this option is selected, press the "wake up"
key of the Windows
power-on the system.
KB Power On Password
Move the cursor to this field and press <Enter>. Enter your pass-
word. You can enter up to 5 characters. Type in exactly the same
password to confirm, then press <Enter>.
The power button will not function once a keyboard password has
been set in this field. You must type the correct password to power-
on the system. If you forgot the password, power-off the system and
remove the battery. Wait for a few seconds and install it back be-
fore powering-on the system.
Hot Key Power On
This field is used to select a function key that you would like to use
to power-on the system.
Onboard FDC Controller
Enabled Enables the onboard floppy disk controller.
Disabled Disables the onboard floppy disk controller.
Onboard Serial Port 1 and Onboard Serial Port 2
Auto The system will automatically select an I/O address
for the onboard serial port 1 and serial port 2.
3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3
manually select an I/O address for the onboard se-
rial port 1 and serial port 2.
Disabled Disables the onboard serial port 1 and/or serial
port 2.
UART Mode Select
This field is used to select the type of IrDA standard supported by
your IrDA device. For better transmission of data, your IrDA periph-
eral device must be within a 30o angle and within a distance of 1
meter.
BIOS Setup
®
98 compatible keyboard to
Allows
3
you to
79