DFI-ITOX LT600-DR User Manual page 74

3
BIOS Setup
IDE Primary Master/Slave UDMA and IDE Secondary Master/
Slave UDMA
These fields allow you to set the Ultra DMA in use. When Auto is
selected, the BIOS will select the best available option after checking
your hard drive or CD-ROM.
Auto
Disabled
SATA Mode
IDE
RAID
AHCI
On-Chip Serial ATA
Disabled
Auto
Combined Mode
Enhanced Mode
SATA Only
SATA Port Speed Settings
Force GEN I
Force GEN II
74
The BIOS will automatically detect the settings for
you.
The BIOS will not detect these categories.
This option configures the Serial ATA drives in IDE
mode.
This option enables the RAID function for Serial ATA
drives.
This option configures the Serial ATA drives in AHCI
mode.
Disables the onboard SATA.
The system will detect the existing SATA and
IDE drives then automatically set them to the
available master/slave mode.
This option allows you to use both IDE and
SATA drives; allowing a maximum of 4 drives.
This option allows you to use both IDE and
SATA drives; allowing a maximum of 6 drives.
This option automatically sets the SATA
drives to Primary Master and Secondary
Master modes. Since both drives are in mas-
ter mode, you cannot set the IDE drives to
Master mode.
SATA will run at 1.5Gb/s which is the first
generation SATA speed.
SATA will run at 3Gb/s which is the second
generation SATA speed.