Power Connectors - DFI-ITOX LT600-DR User Manual

Power Connectors

Use a power supply that complies with the ATX12V Power Supply
Design Guide Version 1.1. An ATX12V power supply has a standard
24-pin ATX main power connector and a 4-pin +12V power con-
nector that must be inserted onto their corresponding connectors.
The 4-pin +12V power connector enables the delivery of more
+12VDC current to the processor's Voltage Regulator Module
(VRM).
The system board requires a minimum of 250 Watt power supply
to operate. Your system configuration (CPU power, amount of
memory, add-in cards, peripherals, etc.) may exceed the minimum
power requirement. To ensure that adequate power is provided, we
strongly recommend that you use a minimum of 300 Watt (or
greater) power supply.
Important:
Insufficient power supplied to the system may result in instabil-
ity or the add-in boards and peripherals not functioning prop-
erly. Calculating the system's approximate power usage is im-
portant to ensure that the power supply meets the system's
consumption requirements.
Hardware Installation
2 1
Ground Ground
+12V +12V
4 3
1 2 2 4
GND
+3.3VDC
+12VDC +5VDC
+12VDC +5VDC
+5VDC
+5VSB
PWR_OK N. C.
GND
GND
GND
+5VDC
GND
GND
PS_ON#
+5VDC
GND GND
-12VDC
+3.3VDC
+3.3VDC
+3.3VDC
1 1 3
2
49