DFI-ITOX LT600-DR User Manual page 40

2
Hardware Installation
S/PDIF-out Connector
The S/PDIF-out connector is used to connect an external S/PDIF-out
port. Your S/PDIF port may be mounted on a card-edge bracket.
Install the card-edge bracket to an available slot at the rear of the
system chassis then
nector. Make sure pin 1 of the audio cable connector is aligned with
pin 1 of the connector.
40
5
N. C.
GND
SPDIF out
Key
1
+5V
connect the audio cable connector to this con-