Init Display First; Onboard Vga; Reset Configuration Data - DFI-ITOX LT600-DR User Manual

3
BIOS Setup
PnP/PCI Configurations
This section shows how to configure the PCI bus system. It covers
some very technical items and it is strongly recommended that only
experienced users should make any changes to the default settings.
x IRQ Resources
** PCI Express Relative Items **
Maximum Payload Size
↑↓→←
F5: Previous Values
The settings on the screen are for reference only. Your version may not be
identical to this one.

Init Display First

Onboard When the system boots, it will first initialize the
PCIEx
PCI Slot

Reset Configuration Data

Enabled
Disabled
86
Phoenix - AwardBIOS CMOS Setup Utility
Init Display First
Reset Configuration Data
Resources Controlled By
PCI/VGA Palette Snoop
INT Pin 1 Assignment
INT Pin 2 Assignment
INT Pin 3 Assignment
INT Pin 4 Assignment
INT Pin 5 Assignment
INT Pin 6 Assignment
INT Pin 7 Assignment
INT Pin 8 Assignment
: Move Enter: Select

onboard VGA.

When the system boots, it will first initialize the PCI
Express x16 graphics card.
When the system boots, it will first initialize PCI.
The BIOS will reset the Extended System Configura-
tion Data (ESCD) once automatically. It will then
recreate a new set of configuration data.
The BIOS will not reset the configuration data.
PnP/PCI Configurations
PCI Slot
Disabled
Auto(ESCD)
Press Enter
Disabled
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
128
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
Item Help
Menu Level
ESC: Exit F1: General Help
F7: Optimized Defaults