Film Tray Status Messages - Kodak Dryview 5800 User Manual

Printer
Local Panel
Status
Warming • Ready LED off
• Warming LED on
• Number of minutes
until warm shown

Film Tray Status Messages

Film Tray
State
Failed • Attention LED on
• Status code: 21000 (upper),
23000 (lower)
• Unlock button LED on
• Cal button LED flashing
• Tray info area displays icon
for this state
Calibrating • Attention LED on
• Status code: 21001 (upper),
23001 (lower)
• Unlock button LED on
• Cal button LED off
• Tray info area displays film
type, size, and count
Film Covered • Attention LED on
• Status code: 21003 (upper),
23003 (lower)
Film Tray • Unlock button LED on
Empty • Cal button LED off
• Tray info area displays film
type, size, and count
2011-09-09
Table 3-2: Printer Status Messages (Continued)
Web Portal
Display
Warming=xx
The following table describes how the local panel and Web Portal indicate
film tray status to the user.
Table 3-3: Film Tray Status Messages
Local Panel
2G0733
DICOM Status
WARNING /
PROC INIT
Web Portal
Display
Failed An error has occurred that
affects normal operation. This
film tray is currently not useable
and requires user intervention.
Calibrating A calibration is in progress for
this film tray.
Film is Covered Either the film bag or film saver
is still on and must be removed
before the film tray can be used.
Empty and/or A film tray is inserted, but the
sheet count of 0 sheet count is 0.
Troubleshooting
Description
The Processor is warming
up and will not be ready to
print for xx minutes.
Description
3-3