Condition Codes - Kodak Dryview 5800 User Manual

Troubleshooting

Condition Codes

Code
01004 MIM Core: Internal Software
Error
04200 MIM Core: Disk Full
06400 MIM Core: Image Page Error
06410 MIM Core: Image Rendering
Error
06411 MIM Core: Image Data Error
06420 MIM Core: Internal Software
Error
06430 MIM Core: Internal Software
Error
10001 MIS: Internal Software Error
3-6
Condition codes are shown on the display screen in the order in which they
are generated. If there is more than one code associated with the current
condition of the imager, the first code is shown on the display screen for six
seconds, while other codes in the list are displayed for three seconds as the
list is cycled. The LEDs on the left side of the local panel will be on
whenever there is a condition code of that type.
Table 3-5: Condition Codes
Web Portal Message User Action
1. Shut down the imager, then start the imager.
2. If the error persists, call for service.
1. Delete jobs in the "Unprintable jobs" queue.
2. Load requested film type for jobs in the "Waiting
for media" queue.
3. If the error persists, call for service.
1. Delete jobs in the "Unprintable jobs" queue.
2. Resend the print job from the image source.
3. If the error persists, call for service.
1. Delete jobs in the "Unprintable jobs" queue.
2. Resend the print job from the image source.
3. If the error persists, call for service.
1. Delete jobs in the "Unprintable jobs" queue.
2. Resend the print job from the image source.
3. If the error persists, call for service.
1. Delete jobs in the "Unprintable jobs" queue.
2. Resend the print job from the image source.
3. If the error persists, call for service.
1. Delete jobs in the "Unprintable jobs" queue.
2. Resend the print job from the image source.
3. If the error persists, call for service.
1. Shut down the imager, then start the imager.
2. If the error persists, call for service.
2G0733 2011-09-09