Table of Contents
Advertisement
Display assembly
NOTE:
Displays are spared only at the subcomponent level. Display assemblies are not spared as whole
units.
Before disassembling the display assembly, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Place the computer in "Battery Safe mode"
3.
Disconnect all external devices connected to the computer.
4.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
5.
Remove the following components:
a.
Service doors
b.
Hard drive
c.
Keyboard
d.
Top cover
Disassemble the display assembly:
1.
Position the computer upright on a flat surface and open the display as far as possible.
2.
Flex the top (1) of the bezel, the inside edges of the left and right sides (2), and then the bottom (3) of
the bezel until it disengages from the display enclosure.
3.
Remove the display bezel (4).
(Service doors on page
(Hard drive on page
38)
(Keyboard on page
41)
(Top cover on page
45)
(Battery Safe mode on page
32).
Component replacement procedures
31).
67
Advertisement
Table of Contents
