Table of Contents
Advertisement
Use this connector when using a voltage
telemetry device to send the battery voltage (DC0
You will need to purchase the optional External
You can then make a cable with an extra
connector to the External voltage connector.
* There is a danger of receiving an electric shock.
* A short circuit across the battery terminals may cause
and
ignite and explode.
The R3008SB receiver is a very versatile
outputs. Additionally the PWM outputs can be
you only desire to use it as an 7 channel receiver
setting changes.
The R3008SB is capable of changing its channel
allocations as described in the table below.
1. Turn on the receiver. (At this moment, the
transmitter should be off.) Then, LED blinks
RED in about 3 seconds. Next, wait until it
becomes solid RED.
2. Press and hold the Mode Switch more than
5 seconds.
3. Release the button when the LED blinks
RED and GREEN simultaneously.
4. The receiver is now in the "Operation
CH Set" mode. At this moment, the LED
a pattern that corresponds to the CH
mode.
*Cannot exit this CH setting mode before the operation
*See the below table that shows correspondence between
*Default CH mode is "Mode B".
5. By pressing the Mode Switch, the operation
CH is switched sequentially as "Mode C"
"Mode D" "Mode A"....
6. The operation mode will be set by pressing
the Mode Switch more than 2 seconds at
the desired CH mode.
7. Release the button when the LED blinks
RED and GREEN simultaneously. Then, the
8. After confirming the operation CH mode
is changed, turn off and back on the
receiver power.
*The "Operation CH Set" mode cannot be changed during
the receiver communicates to the transmitter.
R3008SB CH Mode table
Default CH mode
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Table of Contents
