Receiver Nomenclature; Connector; Led Monitor; Mode Switch - FUTABA T10J Instruction Manual

the following pages.
"1 through 6": outputs for the channels 1
through 6
"7/B": outputs of 7 channels and power.
"8/SB": outputs of 8 channels or S.BUS port.
CH MODE of the following page to mode B or
mode D.
"S.BUS2": outputs of S.BUS2 port.
function or use a second R3008SB and link both
to your transmitter.
Firmly insert the connector in the direction
it 90 degrees.
Do not connect either a switch
or battery in this manner.
This monitor is used to check the CH mode of
the receiver.
Use the small plastic screw driver that was
included with your receiver.
Switch is also used for the CH mode selection.
Danger