Connector - FUTABA FMT-03 Instruction Manual

Connector

Battery SD card
Connector Slot
S.BUS connector (S.I/F)
When setting an S.BUS2 servo and telemetry
sensor, connect them both here.
*Do not connect the battery.
Connector for battery charger
This is the connector for charging the LiFe
battery FT2F2100BV2 that is installed in the
transmitter. Do not use any other chargers except
the attached special charger corresponding to LiFe
battery.
WARNING
Do not connect any other chargers except
the special charger to this charging
connector.
S.BUS (S.I/F) Charge
Connector Connector
Remove the cover and connect trainer
cable. Usually put on the cover.
Connector for trainer function
When you use the trainer function, connect the
optional trainer cable between the transmitters for
teacher and student.
*You can set the trainer function on the Trainer Function
screen in the System menu.
*A transmitter of anything but FMT-03 doesn't correspond to
this trainer system.
*An exclusive option trainer code is needed to use a trainer
system.
Teacher
Trainer
Connector
Change
Student
<Before Use>
21