5Hfhlyhu 56% Qrphqfodwxuh; Connector; S.bus2 Connector; Link/Mode Switch - FUTABA T18MZ Instruction Manual

Receiver nomenclature
Before using the receiver, be sure to read the
precautions listed in the following pages.
Receiver R7008SB

Connector

"1 through 6": outputs for the channels 1 through 6
"7/B": outputs of 7 channels and power.
"8/SB": outputs of 8 channels or S.BUS port.
[S.BUS Sevo S.BUS Gyro ]
"S.BUS2": outputs of S.BUS2 port.
[Telemetry Sensor ]
*When using 9 or more channels, use an S.Bus
function or use a second R7008SB and link both to
your transmitter.
Connector insertion
Firmly insert the connector in the direction
VKRZQ LQ WKH ¿JXUH ,QVHUW WKH 6%86 E\ WXUQLQJ LW
90 degrees.
Warning
S.BUS2 connectors
Don't connect an S.BUS servo / gyro to BUS2
connector.
LED Monitor
This monitor is used to check the CH mode of
the receiver.

Link/Mode Switch

Use the small plastic screw driver that was
included with your receiver.
The Link/Mode Switch is also used for the CH
mode selection.
(The button is not used to link the transmitter
and receiver together. )

Extra Voltage Connector

Use this connector when using a voltage
telemetry device to send the battery voltage (DC0 ~
70V) from the receiver to the transmitter.
Please use an option is External voltage input
cable. Wire in an extra connector to you drive
batteries that mates with the extra voltage connector.
Danger
Don't touch wiring.
* There is a danger of receiving an electric shock.
'R QRW VKRUWFLUFXLW WKH EDWWHU\ WHUPLQDOV
* A short circuit across the battery terminals may cause
DEQRUPDO KHDWLQJ ¿UH DQG EXUQV
POHDVH GRXEOH FKHFN \RXU SRODULW\  DQG 
when hooking up your connectors.
,I  DQG  RI ZLULQJ DUH PLVWDNHQ LW ZLOO GDPDJH LJQLWH DQG
explode.
'RQ¶W FRQQHFWLRQ WR ([WUD 9ROWDJH EHIRUH
turning on a receiver power supply.
<Before Use> 25