Blind Stitch - Pfaff Creative 1467A Instruction Book

Blind stitch
Fold the previously overcast raw edge over to
form a hem of the desired width and baste about
0.5 cm from the fabric edge. Place the fabric
under the blindstitch foot and sew, making sure
the folded fabric edge runs along edge guide "B"
of the blindstitch toot (Fig. 1
+
2a).
Before you
start
blindstitching, adjust the needle
penetration point on the folded fabric edge.
To do this, adjust the position of edge guide "B" by
turning regulating screw 'A' so that the needle
catches only one thread in the folded edge when
it makes its left stitch. Sew a trial seam on a piece
of scrap material first.
• Then proceed as described above (Fig. 2)
/
(for elastic materials)
ro
I', i
06
--
-3+
3
Program 06 is suitable for stretch fabrics. First
fold the hem to the desired width and baste.
Adjust the needle position as described above.
Now you can sew the hem (Fig. 2b).
• Follow the instructions given above,
Blind stitch
2
2b 2a
n7