Pfaff Creative 1467A Instruction Book page 175

Binding edges with
non-woven tape
Fold ready-made bias binding lengthwise and
shape-press. Push the folded binding over the
fabric edge and baste it in place, if required. Then
sew it on with straight stitches (Fig. 1).
Edge-binding with
the binder
Sewing foot: Binder (special accessory)
Program:
00
Stitch length:
2.5 mm, (Fig. a)
or
Program: 10
Stitch-width:
2.5 mm
Stitch length: 1.5 mm,
(Fig. b)
Remove sewing foot and screw on binder. Insert
the bias tape in the scroll of the binder and pull it
out to the rear. Set the binder in such a way that
the needle enters ito 1.5 mm from the turned-in
bias edge. Sew a number of stitches along the
bias tape. Place the raw edge in the groove of the
binder. During sewing, the bias tape
is wrapped
automatically over the material edges. Sew the
bias tape on with the above mentioned program
or a program of your own selection. Straight mate
rial edges are the simplest to bind (Fig. 2).
a
b