Pfaff Creative 1467A Instruction Book page 48

Border 1
prog
--
((3
JJ
41 33 36
-
3—5
2
When tracing the scallops make sure their size
corresponds to the pattern length of the program
selected. Try the pattern out on a fabric scrap first.
First workstep, outside edge
• Select program 41
• Stitch width 6.0 mm
• Pattern length 10 (key 124)
• Press "needle down" key
Sew the selected stitch pattern along the pre
traced line.
Second workstep, centre motif
• Select program 33
• Press "needle down" key
Sew the selected stitch pattern parallel to the
stitch pattern sewn first, offsetting it by the
width of the sewing foot.
Third workstep, innermost motif
• Select program 36
• Press "needle down' key
Sew the selected stitch pattern along the
stitch pattern sewn previously, following it
again at sewing-foot width (Fig. 1).
Sewing fancy seams with
the twin needle
-iL
F
Optional
3—5
I
2
Needle: twin needle, 1.6 mm gauge
Very attractive fancy patterns can be sewn wi h
the twin needle. The illustrations show some )f
the dainty patterns that can be produced with a
little imagination.
If during pattern selection the crossed out twi
needle symbol lights up, the stitch width has to Le
reduced. After the symbol has disappeared, tf e
pattern can be sewn with the twin needle.
For sewing, use two reels of thread of differe't
colours. Place one reel on each reel pin ard
secure
it
in position with the correspondiflg
unreeling disc. Place one thread to the right ard
the other to the left of disc "C". Continue threa I
ing in the usual way, threading each needle sepa
rately. See page 56.
Border 2
• Begin by sewing the centre motif.
• Then sew along the scallops at sewing-foot
width.
• Finally sew the petal-shaped motifs at the scal
lop tips (Fig. 2).
44