Pfaff Creative 1467A Instruction Book page 107

Darning with straight stitch
—n
prog
--
(J
_____
00
—
2—3 6
L__
—
L
Feed dog: lowered
Presser bar lifter: in darning position
Sewing thread:
embroidery and darning
thread
Darning position (Fig. 1):
Lower presser bar lifter "A". at the same t
pushing
it
back slightly until it enters notch "B
the bottom of its slot.
Attaching the darning foot (Fig. 2):
Raise the needle. Push lever "E" towards the b
and hold it there. Insert the pin of the foot in h
"C" and insert the foot so that it rests against
stop. When you do so, guide fork "G" fits aroh
the presser bar. Release clamp "E", which ft
moves down onto retaining screw "F". Tigh;
screw "D".
Draw up the bobbin thread. Hold both three
until the machine has made a few stitches. F
sew a few stitches in the unworn area of the fah
Then stitch over the damaged spot from one s
to the other in serpentine fashion, placing I
lines of stitching close together (Fig. 3). When I
damaged spot has been covered completely, U
the work through 90° and darn at right angles
the preceding row of stitches (see Fig. 4).
You determine the length of the darning stitch
by the rate at which you move the fabric back af
forth.
-,
L
2
98
3