Pfaff Creative 1467A Instruction Book page 181

7-
prog
Sewing thread: Embroid ery and darning thread
General ly buttonho les are sewn onto double
material . In spite of this, a piece of paper should
be placed underne ath during sewing. First mark
the spacings and the distance from the edge. The
points thus obtained always mark the beginnin g
of sewing. Pull the runner of the buttonho le foot
fully to the front before beginnin g the buttonho le.
Sew the first lengthw ise seam at the required
length (Fig. la). Press key 116 "tie-off/ button
hole. After that the Pfaff Creative sews the first
bar and the reverse seam (Fig. 1 b). Shortly before
the end of the reverse seam the machine automa
tically slows down, thus calling attention to the
final bartack that is to be sewn now. Press key 116
(Fig. 1) again one zigzag stitch before the reverse
seam has the same length as the first buttonho le
seam, then sew the second bartack. The machine
automat ically secures the buttonho le at the end
and then stops (Fig. ic). The buttonho le is now
stored. Without actuatin g further keys, the follow
ing buttonho les can now be sewn automat ically.
If you wish to determin e the 2nd bar for a pro
gramme d buttonho le, press key 116. The display
will then show a full stop at the left of program 13.
Shortly before the end of the reverse, seam the
machine automat ically slows down. As soon as
both seams have the same length, press key 116
again. The machine now sews the 2nd bar and
secures the buttonho le.
For sewing the followin g buttonho les it will be
good to lift the fabric a little in order not to affect
feeding of the fabric. The sewing speed must
remain constant .
• If a buttonho le was not program med correctly
it can be cancelle d by selectIng another pro
gram. Select program 13 agaIn and repeat
program ming of the buttonho le.
0
J
2