Step 3. Mount The Tape Drive Into The Server - IBM 200 GB LTO-2 User Manual

Step 3. Mount the tape drive into the server

To mount the LTO-2 into a server:
__ 1. Remove the cover of your server (refer to the instructions in the server's
__ 2. Place the drive into the server so that its tape load compartment faces the
__ 3. Use the supplied mounting screws to mount drive into server. Some server
Attention: When inserted into the LTO-2, the length of the mounting screws must
not exceed 3.5 mm (0.14 in.) inside the chassis. If the length exceeds this
measurement, the tape drive may become damaged.
Figure 3. Mounting holes on Ultrium 2 Tape Drive. The holes are located on both sides of the
drive.
10
IBM 200/400GB LTO-2 Tape Drive: User's Guide
documentation).
front of the server.
installations require use of mounting rails. For these applications, use the
mounting screws to attach rails to the side of the LTO-2 drive and then slide
the drive into the server.