Table of Contents
Advertisement
Table 5. Diagnostic and maintenance functions (continued)
Function Code 2 - Update Tape Drive Firmware from FMR Tapes
Causes the tape drive to load updated firmware from a field microcode replacement (FMR) tape.
Attention: Do not power-off the tape drive while loading code.
1. Make sure that no cartridge is in the drive.
2. Within a 1.5-second interval, press the unload button three times. The status light becomes solid amber, which
means that the drive is in maintenance mode.
3. Press the unload button once per 1.5 seconds until 2 appears in the single-character display. If you cycle past 2,
continue to press the unload button until it redisplays.
4. To select the function, press and hold the unload button for 3 seconds. After you select the function, C flashes.
When C flashes, the drive is waiting for a cartridge. Within 60 seconds, insert the FMR tape cartridge (or the
tape drive exits maintenance mode). After you insert the cartridge, 2 flashes and the tape drive loads the
updated firmware from the FMR tape cartridge into its erasable programmable read-only memory (EPROM)
area:
v If the update completes successfully, the tape drive displays 0, rewinds and unloads the FMR tape, resets
itself, and is ready to use the new firmware.
v If the update fails, the tape drive posts an error code to the single-character display (to resolve the error, see
Table 8 on page 49). The drive then unloads the FMR tape and exits maintenance mode.
Chapter 4. Operating the tape drive
37
Advertisement
Table of Contents
