Chapter 6. Servicing The Tape Drive; Removing A Scsi Tape Drive From An Enclosure - IBM 200 GB LTO-2 User Manual

Chapter 6. Servicing the tape drive

Removing a SCSI tape drive from an enclosure

To remove an IBM 200/400GB LTO-2 Tape Drive from an enclosure, perform the
following steps:
10. Remove the tape drive from the enclosure.
11. To reassemble, reverse these steps.
Figure 18. Rear view of the IBM 200/400GB LTO-2 Tape Drive
© Copyright IBM Corp. 2003
1. Ensure that the tape drive does not contain a tape cartridge.
2. Deconfigure the drive from the server (for instructions, see your server's
documentation).
3. Turn off the power to the enclosure. Disconnect the power cable from the
enclosure and the electrical outlet.
4. Remove the cover of the enclosure.
5. Disconnect the internal power cable from the power connector (see 4 in
Figure 18).
6. If connected, disconnect the internal LDI (RS-422) cable from the LDI (RS-422)
connector 5 .
7. Disconnect the internal SCSI cable from the SCSI connector 2 .
8. Perform one of the following procedures on the SCSI ID connector 3 :
v If your enclosure uses an internal SCSI ID switch, disconnect it from the
SCSI ID connector.
v If your enclosure uses jumpers to set the SCSI ID, do not remove them from
the connector.
9. Remove the mounting screws from the side brackets of the chassis (see 2 in
Figure 3 on page 10).
57