Table of Contents
Advertisement
10. Manually rotate the loader motor gear (see 1 in Figure 22) in the unload
11. While manually rotating the loader motor gear in the unload direction, guide
Figure 22. Guiding the leader block into the home position
64
IBM 200/400GB LTO-2 Tape Drive: User's Guide
9. While keeping the tape taut with your fingers, rotate the allen wrench
clockwise 1 to wind the excess tape into the cartridge. Guide the leader pin
toward the cartridge and drop it inside the cartridge door. Ensure that no tape
is left outside of the cartridge. Remove the allen wrench.
Note: Do not attempt to seat the leader pin into the cartridge's clips; this will
interfere with the motion of the leader block.
direction (counterclockwise) until the leader block 2 reaches the last roller
3 .
the end of the leader block 2 into the white guide block 4 .
Advertisement
Table of Contents
